This post contains some affiliate links for your convenience. Clicking these links will help support this blog so I can keep creating things to share with you, but you will never pay more by using an affiliate link. Click here to read my full disclosure policy.
How to Make A Patterned Tile Wall Stencil DIY
- Patterned tile stencil cut file
- Clear craft plastic
- Silhouette Cameo
- X-acto knife
- Repositionable spray adhesive
- Wall paint
- Foam pouncers
Start by cutting the patterned tile pattern out on the clear craft plastic with your Silhouette. Set the Blade Depth to 10, the Speed to 3 , the Depth to 33 and check the box for Double Cut. Also, I learned that the plastic needs a nice sharp blade to cut cleanly.
If you have any parts that do not cut clean through, you can use an X-acto knife to carefully release them from the wall stencil.
Spray the back of the wall stencil with the repositionable spray adhesive. This will help the stencil stick to the wall while you paint it so you have cleaner lines.
Place the stencil on the wall and start painting it with the paint. I used a navy blue Behr paint sample and it only took about 1/3 of the sample for the entire desk area. When painting you want to only dap at the wall with the pouncer, never rub back and forth because that will push paint under the stencil and you will have messier lines. I wanted a hand-painted look to the patterned tile look so I left the stenciling a little uneven and splotchy. It gives the entire look a lot of texture and depth.
After you finish painting the first stencil, carefully remove the stencil and reposition by lining up the “grout lines” on the outer edge of the stencil. Then paint again and continue around the entire wall area.
I discovered that the paint can start to gum up the stencil and it is helpful if you rinse the paint off every 4-5 times. I rinsed mine in the bathtub by gently rubbing the paint off the stencil. It will not come completely clean but will keep the edges of an intricate stencil cleaner. Reapply the spray adhesive as needed to keep the back of the stencil tacky.
I did the entire back wall of my desk area up until the areas the stencil would not be whole. Then I cut the first stencil I made. Since I centered the stencil on the wall, the amount of patterned needed on either side was even. Using the X-acto knife and a ruler I carefully scored the back of the stencil but made sure not to cut all the way through. Then I folded the stencil so the cut edge would fit in the corner.
Put the altered stencil in the corner and carefully paint the area. Repeat for all corner areas.
Cut another stencil to use for the rest of the area and continue until you have painted the entire wall. Then sit back and admire your work.
I couldn’t be happier with how it turned out, and for practically nothing! Now I have a beautiful place to get all my work done and hopefully be more productive because of it. And if I don’t want to be more productive, at least I have a very fun focal wall to look at 🙂
Don’t forget to check out these other stencil project for the Silhouette Creator’s Challenge.